ABOUT US

Krinklglasì panels are easily installed using any standard or custom framing or mounting if allowance is made for expansion and contraction of the panel and the variation of thickness due to the textured panel surfaces.

A clearance of 1.25 mm per Meter on all dimensions is recommended.

For larger area installations, bowing or sheet deflection must be taken into account, especially for outdoor installations where the panel has to withstand wind forces.

The edge engagement or enlargement around the perimeter of the panels must be a minimum of 3.125 mm for spans under60 cm, above this size, the edge engagement must be proportionately increased until a 2.54 cm stop is to be used in connection with a 3 x 1.5 meter length for exterior applications.

The two prism-like multi-faceted or textured Krinklglasì surfaces provide the unique light dispersion effect, but also create up to 20% variations in the actual panel thickness in some areas. This thickness variation should be considered when inserting panels into frames, extrusions, etc.

No special glazing procedures, framing, extrusions, tape or mastic are needed with Krinklglasì. Any quality, construction grade silicone sealant may be used to provide for any expansion or contraction without fear of leakage. Certain neoprene or similar gasketing can also be utilized.

Krinklglasì can be cut, drilled and worked with common carpentry tools. Its fiberglass reinforcement prevents any shattering or breaking. Panels can be cut on the job site by hand, utilizing a circular, band or saber saw. For best results, use a carbide tipped or carborundum blade or any fine-toothed blade suitable for cutting metal. For bolted or floating assemblies, use a flexible strip around both sides of the inserted panel. The bolt holes must be drilled with an outside diameter (O.D.) slightly larger than the O.D. of the screw or bolt thread to be used. Use a flexible neoprene type gasketing washer with the screw or bolt to provide a solid fit and to avoid stresses when the bolts or screws are tightened. Bolts or screws should be tightened only enough to prevent leakage, and must not be torqued or over-tightened.